※The network is not included. A separate channel divider and three power amplifiers are required. A speaker system composed of TAD TL-1601B+TD-4001+Fostex H200+PIONEER PT-R100 on the custom-made TS15S1 of Tatematsu Onko. Supported by a strong enclosure and tight low frequencies delivered by TAD's 40cm woofer, the mid-high range connection is also well balanced. If you combine it with a multi, you can enjoy a lot of powerful sounds (Tetsuji Oikawa)
Maintenance information: 2022.4.10 operation confirmed
Accessories: None
Main specifications: TL-1601B: 40cm cone type woofer 8Ω playback frequency band 28Hz to 1kHz rated input 200W maximum input 500W output sound pressure level 97.5dB TD-4001: medium and high Range Driver Beryllium Diaphragm Aperture 49.2 mm 600 to 20,000 Hz Recommended Crossover Frequency 600Hz Alnico Magnet Impedance 16Ω Efficiency 110dB PT- R100: Ribbon Type Beryllium Diaphragm 8Ω 98dB 5kHz to 120kHz W698xH895xD515mm
A 20cm full range unit from Telefunken taken from a home radio manufactured in Germany around 1950 is used. You can enjoy natural sound with an open rear cabinet designed to move lightweight units lightly (Takasaki Atsushi)
Maintenance information: 2023.2.2 sound output confirmed
2018.11.5 Maintained (lead wire stripped, edge torn fixed)
Accessories: none
Main specifications: 20 cm cone type full range unit, efficiency 96 dB, input resistance, 5 watts, Finnish birch wood, open back cabinet, W38 x H58 x D30 cm, approx. 10.5 kg/book (actual measurement)
*There is no problem with operation, but since it is inexpensive, it is currently sold. DIY AUDIO speaker system equipped with SA/F80AMG. There are tape marks, small scratches, and dents on the cabinet (Oikawa Tetsuji)
Maintenance information: 2023.1.14 sweep tested
Accessories: none
Main specifications: W160 x H300 x D250 mm 3.5 kg (actual measurement)
A speaker system in which two pairs of TAD TD-4001 and TL-1601A woofers are configured in vertical twins on horns in an enclosure using Taguchi Seisakusho's Apiton material. It is a full-fledged specification that supports bi-amp drive with built-in network and multi changeover switch. Casters are attached to the legs, making it easy to set up. One long repair scratch on one woofer, light dent wrinkles on the center cap of one woofer, noticeable line scratches on the top surface, abrasions and line scratches in some places (Yoichi Murakoshi)
Maintenance information: 2022.4.16 sound confirmed
Accessories: None
Main specifications: 2-way 3 speakers TL-1601A 8Ω 97dB TD-4001 16Ω 110dB crossover 800Hz W650 × H1360 × D740mm