* There is no problem with operation, but since it is inexpensive, it is currently sold. Musica's vacuum tube premain amplifier. This is a limited edition of 50 units with high sound quality based on the INT62 using the power stage of the company's POW62. You can enjoy compact yet powerful and warm analog sound. As for the exterior, there are scratches on the top plate. (Miura Kimiya)
Maintenance Information: 2022.10.12 Operation confirmed
Accessories: instruction manual, AC adapter
Main specifications: output 50W+50W frequency characteristics 1Hz to 100kHz input RCA3 system W217 × H65 × D197mm
The price has been drastically reduced. 2022/6/14 selling price 198,000 yen. It's been maintained! The VTL's first integrated amplifier power amplifier tube EL34 is push-pull connected to a 60W vacuum tube, realizing dynamic music playback with a large output. It also has excellent tonal balance and expressive power in the midrange. It has a vacuum tube circuit headphone output. There is a feeling of use overall (Kanai Hidetsugu)
Maintenance information: 2022.6.14 maintained (with motor volume decomposition cleaning left ch noise → output tube replacement power off and mute pop sound comes out → resistor exchange SN is bad (especially Right ch) → replace the front vacuum tube
(Remote control decomposition conductive paint reapplication solder correction rotary switch cleaning remote control filter disconnection correction insect damage removal bias adjustment output 8Ω about 60W voice checked.)
Accessories: remote control, power cable
Main specifications: Output: 60W+60W (8Ω) /80W+80W (4Ω) Line input 5 systems Power amplifier · Direct input 1 system Speaker output 1 system Power consumption 200W (when idling), 600W (at maximum output) W400 × H195 × D280 mm Weight: 20.5 kg
The disposal price has been reduced! (Member discounts are not applicable) 2023/12/29 sales price 99,800 yen Maintenance completed! The design full of oldies is attractive, and Newcam's mono mixer premain for PA. 6L6 is used as the output tube. Channel 1 is compatible with LINE, PHONO, and MIC, and channels 2 to 4 are compatible with microphones. The volume for each channel is around 12 o'clock, and MASTER is used for volume adjustment. There is a feeling of use such as small scratches and paint deterioration appropriate to the exterior model year (Kobayashi Hitoshi)
Maintenance information: 2023.12.12 maintenance (master volume disassembly, cleaning repair, MIC input transformer, etc. contact repair, left side front lamp off, 12AX7, 150 μF electrolytic capacitor replacement. Vacuum tube socket and RCA jack caulk repair. Operation checked (measured at 41 to 61 W SP: 8 Ω with rated output AC 100 to 117 V).
Accessories: none
Main specifications: 6L6 push-pull 60W mono LINE, 1 PHONO system each, MIC4 system W440 x H190 x D350 mm 16.5 kg
MAINTENANCE! Orthophone bulb primain amplifier. Equipped with a phonoequalizer that is compatible with MM/MC like the company. The output part that adopts 4 KT88 is 3 pole, 5 pole connection and NFB can be adjusted by switch, so you can enjoy a variety of speakers and various music genres. There are scuffs and line scratches on the side and front wood part (Yoichi Murakoshi)
Maintenance information: 2021.6.23 Maintenance (all wiring, board takeout, relay replacement, total modification of each part soldering. Power supply unit, Bias power supply unit capacitor capacitance measurement, KT88 × 1 replacement, fixed bias reset, running test.)
Accessories: Instruction manual, power cord
Main specifications: 32W+32W (UL), 16W+16W (TRI) vacuum tube KT88×4, 12AU7×2, 12AX7×2 W353 × H200 × D278mm 15.5 kg
The price has been reduced! 2021/11/28 Sales price 118,000 yen Orthophone tube premain amplifier. Equipped with a phono equalizer compatible with MM/MC that seems to be the company. The output unit, which adopts four KT88, can be connected to a triode tube, a five-pole tube, and NFB can be adjusted by a switch, so you can enjoy a variety of speakers and various music genres. The appearance is generally beautiful without noticeable scratches. Serial 14100262 (Asaine Tomoho)
Maintenance information: 2021.11.28 Operation confirmed
Accessories: Instruction manual power cord gloves original box
Main specifications: 32W+32W (UL) 16W+16W (TRI) used vacuum tube KT88 × 4 12AU7 × 2 12AX7 × 2 W353 × H200 × D278mm 15.5kg
The price has been reduced. 2021/12/20 sales price 99,800 yen Maintained! An easy-to-use pre-main amplifier recommended for vacuum tube amplifier beginners. It expresses a sense of volume and scale that you can't think of as 15W, and while having a sweet sound, it extends well from low to high frequencies, so it supports the latest sources well. * If you raise the VOL considerably on a CD player with a large output, the sound will be distorted due to input over, but it is a specification (Yoichi Murakoshi)
Maintenance information: 2021.12.19 maintenance (volume connection sleeve screw hole re-drilling tap cutting, cathode resistor replacement, screw tightening, vacuum tube pin cleaning, bias check, output audio (Check, interior and exterior cleaning.)
Accessories: power cord
Main specifications: used vacuum tube EL84 12AU7 12AX7, 15W+15W (8Ω), W405XH120XD320mm 12kg
Disposal prices have been reduced! (Member discounts do not apply) 2022/12/23 sales price 230,000 yen Maintenance completed! Tubular pre-main amplifier kit with 7591 push-pull configuration. The high-energy sound quality and warm tone are appealing. The sound of JAZZ played by a small speaker of the same age is excellent. The generation of EQUALIZATION switch switching noise is a specification. *When using AC100V, set BIAS on the white mark. On the exterior, there are abrasions on the lower right corner of the front panel, and age-like rust spots can be seen throughout (Yonejima Satoshi)
Maintenance information: 2022.12.23 Maintained (changeover noise improvement measures. BIAS and AC BAL readjustment. Vacuum tube socket and RCA jack recalibration repair. Other operations have been checked (measured at 14 to 25 W SP: 8 ohms with rated output AC 100 to 117 V)
Accessories: no accessories
Main specifications: Tubular pre-main amplifier kit output 80W input sensitivity/low level 3.5mV/tuner, Aux1/2 350mV output terminal 4Ω, 8Ω, 16Ω W384 × H138 × D348 mm (actual measurement) 12.8 kg (actual measurement)
The price has been drastically reduced. 2023/9/21 sales price 148,000 yen maintenance completed! A BOCAMA tube premain where you can enjoy powerful sounds in a small body. 12W x 2 outputs in a 6BQ5 push-pull configuration. The phono section has a ceramic and magnetic switch. ※There is no ground terminal for phono, so please fasten it with a screw on the chassis (Yoichi Murakoshi)
Maintenance information: 2023.9.20 maintenance (poor contact improvement treatment for each part, replacement of 12 capacitors, change to SP16Ω and original negative feedback circuit. Vacuum tube socket and RCA jack caulking repair, operation check.)
Accessories: none
Main specifications: Vacuum tube used 6BQ5 × 4, 12AX7 × 5, 6AR4 12W+12W (8, 16Ω) W355 × H120 × D260 mm 8.5 kg
Disposal price cut! (Member discount not applicable) 2021/2/18 Selling price 198,000 yen Laxman uses a traditional, natural wood veneer finish wood case, profound aluminum knob, etc. A model reprinted with a traditional layout. EL84 is installed in parallel push-pull configuration. Modern clarity is added to the lustrous tone unique to the vacuum tube. Appearance, there are some scratches on the top plate. Serial G40700334 (Eiji Tamura)
Maintenance Information: 2021.2.17 Operation confirmed
Accessories: Remote control, instruction manual, power cable
Main specifications: Effective output 16W+16W (6Ω) 15W+15W (8Ω) 12W (4Ω) Parallel push pull EL84 × 8 pcs/ECC83 × 1 pcs/ECC82 × 2 Dimensions W400 × H166.5 x D400mm Weight 19.5kg
Prices have been reduced! 2023/11/2 sales price 198,000 yen manufacturer maintenance completed! This model uses a wooden case with a natural wood veneer finish, and has been reprinted with a traditional Laxman layout, such as heavy machined aluminum knobs. The EL84 is equipped with a parallel push-pull configuration, and modern transparency has been added to the glossy tone unique to vacuum tubes. Serial G40700391 (Tomonori Asaina)
Maintenance information: 2023.11.2 maintenance completed (Lch driver vacuum tube defect, replacement, replacement of all other vacuum tube deterioration. Connector contact defect correction, correction base pattern and solder deterioration correction, selector switch contact cleaning, other inspection running tests, comprehensive adjustments, operation tests)
Accessories: remote control power cord
Main specifications: effective output 16W+16W (6Ω), 15W+15W (8Ω), 12W+12W (4Ω) parallel push-pull EL84 x 8, ECC83 x 1, ECC82 x 2 W400 x H166.5 x D400 mm 19.5 kg
Manufacturer maintenance has been completed! Using a wood case finished with natural wood veneer, this model was reprinted in the traditional layout of Laxman, such as a machined aluminum knob full of profound feeling. Equipped with the EL84 in a parallel push-pull configuration, modern clarity is added to the glossy tone unique to vacuum tubes. Serial 640700450 (Mizushima Itsuro)
Maintenance information: 2021.12.9 maintenance (power supply circuit (B power supply) fuse replacement. Replace all power tubes. SG circuit zener di adjustment. (Other checks, operation tests.)
Accessories: Instruction manual, power cable, original box
Main specifications: Effective output 16W+16W (6Ω), 15W+15W (8Ω), 12W+12W (4Ω) parallel push-pull EL84 × 8, ECC83 × 1, ECC82 × 2 W400 × H166.5 × D400mm 19.5kg
Price down (2021.3.25 selling price 198,000 yen) Using a wood case finished with natural wood veneer, this model has been reproduced with the traditional layout of Racksman, such as a machined aluminum knob full of heavy feeling. Equipped with the EL84 in a parallel push-pull configuration, modern clarity is added to the glossy tone unique to the vacuum tube. Appearance, there are some scratches on the top plate. Serial G40700334 (Takasaki Aki)
Maintenance Information: 2021.3.25 Operation confirmed
Accessories: Remote control, instruction manual, power cable
Main specifications: Effective output 16W+16W (6Ω), 15W+15W (8Ω), 12W+12W (4Ω) Parallel Push Pull EL84 × 8, ECC83 × 1, ECC82 × 2 W400 × H166.5 × D400mm 19.5kg
A model that uses a traditional Luxman wood case finished with natural wood veneer, and has been reprinted with a traditional layout such as a profound machined aluminum knob. The EL84 is mounted in a parallel push-pull configuration. Modern transparency is added to the glossy tone unique to vacuum tubes. The appearance is good with dullness (Hitoshi Kobayashi)
Maintenance information: 2021.12.9 maintenance (power supply B) fuse replacement. Replace all power tubes. SG circuit zener di adjustment. (Other checks, operation tests.)
Accessories: remote control, power cord, original box
Main specifications: effective output 16W+16W (6Ω), 15W+15W (8Ω), 12W+12W (4Ω) parallel push-pull EL84 × 8, ECC83 × 1, ECC82 × 2 W400 × H166.5 × D400mm 19.5kg
A model that uses a traditional Laxman wood case finished with natural wood veneer, and is reprinted with a traditional layout such as machined aluminum knobs full of profound feeling. Equipped with the EL84 in a parallel push-pull configuration. Modern transparency is added to the glossy tone unique to vacuum tubes. The appearance is dull. Serial G50600668 (Satoshi Yonejima)
Maintenance Information: 2022.6.7 Manufacturer maintained (all vacuum tubes EL84 replaced. Vacuum tube power supply fuse replacement Comprehensive adjustments. Operation characteristic test OK) 2021.1.22 Manufacturer maintained (all power tubes (EL84) replaced. Replaced the driver tube (ECC82) and the first stage pipe (ECC83). (Inspection of other parts, operation test, hearing test OK)
Accessories: remote control, power cord, instruction manual, original box
Main specifications: Effective output 16W+16W (6Ω), 15W+15W (8Ω), 12W+12W (4Ω) parallel push-pull EL84 × 8, ECC83 × 1, ECC82 × 2 W400 × H166.5 × D400mm 19.5 kg